Expression 3 - ETC

Hold dwell time
If you record a submaster with a dwell time of Hold, the submaster fades
up when you press the bump button, then holds until you press it again.
To add a dwell time of Hold to a submaster, follow these steps:
Keystrokes:
Action:
1. Press [Sub]. Prompt reads:
Select submaster number
To select submaster type, press
TYPE
2. Press [5]. Selects submaster 5
Corner reads: Sub 5
3. Press [Time] [Time]. Prompt reads:
Enter dwell time
(For hold or manual operation,
press CLEAR until desired setting
appears)
4. Press [Clear]. Corner reads: Dwell Hold
5. Press [Enter] [Enter]. Dwell time is set to Hold for
submaster 5
Manual dwell time
If you record a submaster with a dwell time of manual and an upfade time
other than zero, the upfade starts when you press and hold the bump
button. It runs until channels reach full recorded levels, then holds at full
as long as you hold the bump button; the downfade begins when you
release it. If you don’t hold the bump button for the duration of the upfade
time, channels do not reach their full recorded levels.
Follow this procedure in Blind to convert a timed dwell to a manual dwell. 4
Keystrokes:
Action:
1. Press [Blind] [Sub]. Prompt reads:
Select submaster number
To select submaster type, press
TYPE
2. Press [5]. Selects submaster 5
Corner reads: Sub 5
3. Press [Time] [Time]. Prompt reads:
Enter dwell time
(For hold or manual operation,
press CLEAR until desired setting
appears)
4. Press [Clear] [Clear]. Corner reads: Dwell Man
5. Press [Enter] [Enter]. Dwell time is set to Manual for
submaster 5
166 Chapter 13 Submasters