Expression 3 - ETC

Error messages
ETCLink provides messages for a wide variety of conditions, including
information regarding your dimmers, racks, system, data, ports, and
loads. These messages fall into two categories, fatal messages and
secondary messages. 2
Fatal messages deal with anything that could potentially terminate or
drastically change the look of your show. You may set fatal messages to
be displayed even when secondary messages have been disabled.
Secondary messages deal with individual dimmer problems and warnings
of potential rack temperature problems. These messages are generally
less critical than the fatal messages. If you wish, secondary messages
may be disabled without disabling fatal messages. The procedure for
enabling or disabling ETCLink error messages is given in the next section.
The console shows error messages in pop-up advisory windows that
appear regardless of which display mode you have chosen. They may also
appear in abbreviated forms on the Status and About screens. 3 Advisories
are cleared as soon as you enter any keystroke. An example of such an
Advisory message is shown below.
2.
See ETCLink errors, page 357, for a listing of errors.
3.
To identify errors on specific dimmers, see About Dimmer with
ETCLink, page 52.
Expression 3 User Manual, v.3.1 267