Expression 3 - ETC

Modifying step timing and levels
Once all steps are defined for an effect, you can either accept the defaults
or you can change one or more settings in a single operation. The step
defaults are as follows:
• Step Time 0.2 seconds
• In Time 0 seconds
• Dwell Time 0 seconds
• Out Time 0 seconds
• Low Level Zero
• High Level Full
Set step timing and levels of a recorded effect with the following
procedure. 19
Keystrokes:
Actions:
1. Press [Blind] [Cue] [1]. Go to the effects display for a
previously recorded effect cue
Prompt reads:
Select cue number
To write effect, press STEP
2. Press [S1], Step, [5]. Specifies step 5
Prompt reads:
Select step number(s)
(To clear step(s), select step
number(s), then press CLEAR)
3. Press [S7], More
Softkeys, [S2], Step
Time.
Selects step time field
Prompt reads:
Select step time
4. Press [1][0] [Enter]. Sets step time to 10 seconds and
advances to the next field
Prompt reads:
Select step in time
5. Press [2] [Enter]. Sets step in time to 2 seconds and
advances to the next field
Prompt reads:
Select step dwell time
6. Press [6] [Enter]. Sets dwell time to 6 seconds and
advances to the next field
Prompt reads:
Select step out time
19.
Press [→] or [Enter] without a number to skip any selection.
Expression 3 User Manual, v.3.1 221