Expression 3 - ETC

Installing the console and monitors
Follow these steps to install the Expression 3 console and its monitors:
1. Place console on a hard, stable, flat surface. Leave at least six inches
of space behind console for ventilation and cable clearance. Console
should be at least six feet from dimmers and high-current AC lines.
CAUTION: Do not leave the console in a road case tray or on a soft
surface. This will inhibit proper ventilation.
2. Move console power switch (by fan on back panel) to the Off position.
3. Connect the video cable from the monitor to the console connector
labeled CRT 1 on the back panel. Repeat for second monitor, using
CRT 2.
4. Insert the female end of the console power cord into the connector
labeled Power in on the console's back panel.
5. Insert the female end of the monitor power cord into the connector
on the back of the monitor.
6. Insert the male end of the monitor power cords into the console
connector labeled Switched AC Outlets.The switched AC outlets
provide the same voltage as that supplied to the console in Step 7,
below.
7. Insert the male end of the console power cord into a grounded power
outlet.
VGA monitor connections
Connector
HD-DB15 female
VGA monitor pinout
1 Red video
2 Green video
3 Blue video
4 Ground
5 Ground
6 Red ground
7 Green ground
8 Blue ground
9 not connected
10 Ground
11 Ground
12 not connected
13 Horizontal (H/V) sync
14 Vertical sync
15 not connected
Note: In some installations you may need additional grounding. An
additional grounding location is provided on the rear of the console for this
purpose. This console is not certified for use in wet locations.
328 Appendix A Installation