Expression 3 - ETC

Adding groups or focus points
The procedure for creating an effect in Stage and adding one or more
recorded groups or focus points to its steps is shown below. 18
Keystrokes:
Actions:
1. Press [Stage] [Cue] [6]. Specifies cue 6
Prompt reads:
Select cue number
To select cue type, press TYPE
2. Press [Type] [3]. Defines the cue as an effect type
Prompt reads:
Select channel numbers
3. Press [Group] [5] [And] [8]
[Full]. a
4. Press [Record] [Enter]. b
5. Repeat steps 3-4 to create
other steps. c
Captures groups 5 and 8 at full on
stage
Prompt reads:
Group mode - Press AT or use wheel
or trackpad to alter levels, or select
channels numbers to edit
Records the step and advances the
step indicator to the next in sequence
Prompt reads:
Select channel numbers
a.
b.
c.
Substitute [Focus Point] for [Group] to add one or more focus
points.
Specify the step number after [Record] if you do not want to
create the next step in order. See Notes on working with
steps in Stage, page 212.
You may also use either of the other two methods discussed
in this section to create additional steps.
18.
Channels added in Stage in focus points do not update in the effect
whenever the focus point changes.
Expression 3 User Manual, v.3.1 213