Expression 3 - ETC

Adding groups or focus points
The procedure for creating steps by adding groups or focus points to them
in the Blind Effects display is shown below. All channels in a group or
focus point are added to the step(s) together but they may be edited
individually later.
Keystrokes:
1. Press [S1], Step, and enter
the step number. A new
step must always have the
next highest number,
beginning with step 1.
2. Press [Group] [5] [Thru]
[1][0]. a
3. Press [S8], Add
Channels.
Actions:
Specifies next step to be created.
Prompt reads:
Select step number(s)
(To clear step(s), select step
number(s), then press CLEAR)
Selects groups 5 through 10.
Prompt reads:
Group mode - Select group(s) and
press ADD CHANNELS to add to
step(s), or press AT to edit existing
channel level(s)
Adds groups’ channels to step.
Prompt reads:
Group mode - Select group(s) and
press ADD CHANNELS to add to
step(s), or press AT to edit existing
channel level(s)
4. Press [Record] [Enter]. Records the channels to the effect
step. Prompt reads:
Select cue number
To write effect, press STEP
a.
To add focus points rather than groups, press [Focus Point]
rather than [Group] in this step.
210 Chapter 16 Effects