Expression 3 - ETC

Setting channel levels
You assign output levels to channels using the basic format [Channel] [#]
[At] [#] where the first number is the channel and the second is the level.
For example, [Channel] [4] [At] [7][5] sets channel 4 at 75 percent. If you
enter a single digit for the level, the console multiplies it by ten and you
must follow it with [Enter]. In other words, [Channel] [4] [At] [1] [Enter]
sets channel 4 to 10 percent. To set channel 4 to 1 percent, enter
[Channel] [4] [At] [0][1]. 32
Level wheel
To set channel levels with the level wheel (labeled Level Y), select the
channels whose levels you want to modify, then use the level wheel to
set the desired output level. You can also use the level wheel to adjust
output levels for all active channels.
To set selected channel levels, enter [Channel] [1] [Thru] [5] then move the
level wheel to set levels.
To modify all channels currently at a level above zero, press [Enter] then
move the level wheel to set levels.
Full
Press [Full] to set selected channel levels to 100 percent. For example,
press [Channel] [1] [Thru] [3] [Full] to set channels 1, 2 and 3 to 100
percent.
Level key
Flash
[Level] sets selected channel levels to the output level assigned to the
[Level] key. The default value for [Level] is 100 percent. (See Setting
default Level key, page 27, for instructions on changing the Level key’s
setting.) For example, if Level is set at 75 percent, press [1] [Thru] [5]
[Level] to set channels 1, 2, 3, 4, and 5 to 75 percent.
Flash sets the selected channel’s level to 100 percent if the channel is
currently at a level at or below 50 percent. If the channel’s level is above
50 percent, Flash sets it to zero. Levels set by Flash are only maintained
while the key is pressed. For example, press [Channel] [5], then press and
hold [S8], Flash, to set channel 5 to either 100 or zero.
32.
To clear channels, press [At] [Clear].
62 Chapter 5 Setting channel levels