Expression 3 - ETC

Remote macros
The remote macro feature provides the ability to control up to 8 console
macros from locations up to 1,000 feet away. Typically the Remote Macro
control device is an eight button control station.
The remote macro terminals on the console rear panel control macros
1,901 through 1,908. 18 To operate one of these console macros from a
remote location, press the appropriate control.
ETC does not provide remote macro control units. However, the console
does provide a 25-pin connector labeled Remote Macro to which you may
attach a user-supplied, remote macro control device. See Installing
remote macros, page 344 for more information about connecting a
remote macro controller to your console.
Serial interface
The rear panel connector labeled Digitizer/Serial is intended for the
attachment either of a digital tablet or to make a serial connection to
another device. For information about using a digital tablet with your
console or Lighting Playback Controller, See Designer’s Worksheet, page
315.
Please note that the serial interface feature has been reserved for future
implementation. Disregard the Expression Serial Protocol (ESP) choice in
option 12 on the Options Settings menu. Also disregard softkey [S2], ESP
Baud Rate, in that menu.
18.
The Expression Lighting Playback Controller has 32 remote macros
that are wired to four connectors on the LPC rear panel. These macros
are numbered 1,901 through 1,932. See the Expression LPC
QuickGuide for further information.
Expression 3 User Manual, v.3.1 311