Expression 3 - ETC

Adding fade and dwell times
You can add fade and dwell times to a submaster from Stage or Blind
mode. To add fade times to a submaster, follow these steps in either
mode:
Keystrokes:
Action:
1. Press [Sub]. Prompt reads:
Select submaster number
To select submaster type, press
TYPE
2. Press [5]. Selects submaster 5
Corner reads:
Sub 5
3. Press [Time]. Prompt reads:
Enter upfade time
4. Use keypad to enter
upfade time and press
[Time].
5. Use keypad to enter dwell
time and press [Time].
(See next page for
information about using a
Hold dwell.)
6. Use keypad to enter
downfade time and press
[Enter].
Prompt reads:
Enter dwell time
(For hold or manual operation,
press CLEAR until desired setting
appears)
Prompt reads:
Enter downfade time
New fade times are recorded into
submaster 5
Note: Once a timed submaster is running, press the bump button to
change the direction of the fade. For example, if the upfade is half
finished, pressing the bump button starts the downfade from 50 percent.
If a downfade is running, pressing the bump button begins an upfade
again from the current level.
Expression 3 User Manual, v.3.1 165