Expression 3 - ETC

Channel check
Use a Channel Check to check which channel controls which light. The
console allows you to check channels by selecting a single channel and
flashing it to a level. 34 Once you have selected a channel you can then
advance sequentially through the channels, checking one at a time. You
may start a channel check with any channel.
Follow these steps to run a channel check:
Keystrokes:
Actions:
1. Press [Stage]. Selects Stage display
Prompt reads:
Select channel numbers
2. Press [Channel] [1]. Corner reads: Chan 1
3. Press [S7],
More Softkeys.
4. Press and hold [S8], Flash. Sets channel 1’s level to 100 percent if
its current level is at or below 50
percent
or...
Sets channel 1’s level to zero if its
current level is above 50 percent
5. While holding [S8], press
[+] or [–] to select the next
or previous channel.
Flashes each channel in turn
6. Once you have checked all
the channels, release [S8],
Flash.
34.
If a channel is independent, it will not flash in response to a channel
check.
64 Chapter 5 Setting channel levels