Expression 3 - ETC

Using the Park display
Most examples in this chapter illustrate the use of the Park command in
the Stage display. You can also perform all the same operations in the Park
display, but without the need to use the Park command. The parked
channels and dimmers are displayed in the Park display with their levels
and focus point links, if any. 10
Parking dimmers
Park a dimmer by specifying the dimmer number and level. You may park
multiple dimmers at once. When dimmers are parked, the message
Parked Dimmers appears in the lower right corner of the Stage display.
Park one or more dimmers as follows:
Keystrokes:
Action:
1. Press [Stage]. Selects Stage display
2. Press [S6], Park, [Dim]. Prompt reads:
Select dimmer number(s), then
press ENTER to park, press AT to
select level, or press RELEASE to
unpark
3. Enter the dimmer
number(s) to park, then
press [At]. a
4. Enter the level at which
to park the dimmer.
Selects the dimmer to park
Prompt reads:
Enter intensity for park dimmer(s)
Parks the dimmer at the selected level
Alert appears:
Parked Dimmers
a.
In all references in this chapter to the use of [At] to set a level,
you may substitute the [Full] or [Level] keys.
10.
See Park, page 18, for information about using the Park display.
198 Chapter 15 Park