Expression 3 - ETC

Enabling LTP
You can set a channel’s status to LTP or HTP as long as the channel is not
used in Fixture Patch. If the channel is patched to a fixture, the personality
controls the HTP/LTP status. All attributes (channels) are set to LTP by a
personality except the intensity attribute. All channels not patched to a
fixture default to HTP (considered “normal”).
Set channels to HTP or LTP, either singly or in ranges, in the Channel
Attributes display using the following procedures.
Keystrokes:
Action:
1. Press [Setup] [1][1] [Enter]. Selects the channel attributes display
2. Press [1] [Thru] [1][0]
[Enter].
Specifies channels 1 through 10
3. Press [→] [→] [→] [→]. Move to LTP field
4. Press [1]. Sets channels to LTP
Working with LTP channels
Background overrides
Cues running in the background can be stopped, adjusted or otherwise
controlled with background overrides. 2 There are five override options, as
shown in the table below.
Background Override Operations
1. Clear Cue(s) Clears cue levels.
2. Cancel Cue(s) Stops the fade or effect.
3. Finish Cue(s) Takes cue channels to their completed
levels immediately.
4. Master Cue(s)
on X-Wheel
5. Alter Rate of Cue(s)
on X-Wheel
Control background overrides as follows:
Keystrokes:
1. Press [Stage] [S3],
Background Overrides.
2. Press [5] [Enter]. a
Takes proportional control of cue
levels immediately.
Adjusts cue timing.
Action:
Selects the Background Overrides list
Specifies cue 5
3. Press [#] [Enter]. Specifies the override operation you
want performed
a. Press [0] in this step to apply an override operation to all cues.
2.
Identify which cue contains a particular channel from the About
Channel display, covered under About Channel, page 65.
Expression 3 User Manual, v.3.1 5