Expression 3 - ETC

Adding grouped channels
The procedure for creating steps in the Stage by adding channels grouped
from cues or submasters is shown below.
Keystrokes:
Actions:
1. Press [Stage] [Cue] [7]. Specifies cue 7
Prompt reads:
Select cue number
To select cue type, press TYPE
2. Press [Type] [3]. Defines the cue as an effect type
Prompt reads:
Select channel numbers
3. Press [Group] [Cue] [1]
[And] [2] [Full]. a
4. Press [Record] [Enter]. b
5. Repeat steps 3-4 to create
other steps. c
Captures the channels of cues 1 and 2,
setting all to full
Prompt reads:
Group mode - Press AT or use wheel
or trackpad to alter levels, or select
channels numbers to edit
Records the step and advances the
step indicator to the next in sequence
channels to the effect step
Prompt reads:
Select channel numbers
a.
To add grouped submasters rather than grouped cues, press
[Submaster] rather than [Cue] in this step.
b.
Specify the step number after [Record] if you do not want to
create the next step in order. See Notes on working with
steps in Stage, page 212.
c.
You may also use either of the other two methods discussed
in this section to create additional steps.
214 Chapter 16 Effects