Expression 3 - ETC

Changing dwell only
Follow these steps to change only the effect’s dwell time:
Keystrokes:
Resetting hold dwell time
Action:
1. Press [Blind] [Cue] [2]. Selects cue 2 in the Blind display
2. Press [Time] [Time]. Prompt reads:
Enter effect dwell time
3. Enter the dwell time. Prompt reads:
Enter effect dwell time
4. Press [Enter] [Enter]. Prompt reads:
Select step numbers
If the dwell time is set to Hold, an effect submaster will continue to run
until you press the bump button. An effect cue will continue to run until
you press either [Go] or [Hold] [Hold]. To reset the dwell time to Hold
follow these steps:
Keystrokes:
Action:
1. Press [Blind] [Cue] [2]. Selects cue 2 in the Blind display
2. Press [Time] [Time]. Prompt reads:
Enter effect dwell time
(Press CLEAR for hold)
3. Press [Clear]. Hold appears in the Dwell box of the
cue attribute line
4. Press [Enter] [Enter]. Dwell time set to Hold
Prompt reads:
Select step numbers
224 Chapter 16 Effects