Expression 3 - ETC

Go to the Attribute Setup display
The Attribute Setup display lists all attributes and identifies their category
assignments. You can change the categories to which an attribute is
assigned by adding or removing them in this display. Every attribute must
be assigned to at least one category. Multiple category assignments are
allowed except when an attribute is assigned to the None category.
1. Press [Setup] [1][5] [Enter] to display the Moving Light Functions
menu.
2. Press [3] [Enter] to go to the Attribute Setup display.
Navigation and Feedback - Attribute Setup display
[S] ±
Select an attribute X X X X
Select a category X X
Make a change
X
Purple coloration
Attributes used in the show
Gray coloration
Attributes not used in the show
Yellow coloration
Item selected
Changing an attribute’s category assignment:
1. Enter the number of the attribute. Press [Enter].
2. For each category to be added or removed, enter its assignment
number (0=None; 1=Position; 2=Image; 3=Color; 4=Beam).
Entering the number either adds or removes the category depending
upon whether the attribute is already assigned to it or not.
3. Press [Enter] after you have made all changes. You may start over at
any time by pressing [Clear] or typing 0 to choose None.
Resetting defaults:
Each of the 64 attributes has a unique default category assignment. To
reset all attributes to their category defaults, go to the Attribute Setup
Display. Then, Press [S7], Reset Defaults, followed by [Enter].
76 Chapter 6 Adding moving lights to the show