Expression 3 - ETC

Setting levels without encoders
Use the procedure below this Navigation and Feedback table to set
attribute levels without the use of encoders, such as when you are using
a console without an attached ML module
Navigation and Feedback - Fixture Box display (without encoders)
±
Select fixture X X
Select page
Select attribute
Page highlighted white
Page highlighted yellow
Attribute gold
Attribute highlighted yellow
X
X
Fixture attributes
exist on page
Selected page
Attribute of
selected fixture
Selected attribute
1. With a fixture in the Fixture Box, press the up/down arrows to select
a page.
2. Select an attribute with the left/right arrows.
3. Adjust the level of the selected attribute with the Y-wheel. 9
4. If there are other fixture attributes on the same page that you wish to
set, repeat steps 2 and 3 above. Continue until finished with all
attributes on that page.
5. If attributes of this fixture are on a different page, repeat steps 1
through 4 above. Continue for all pages on which the fixture’s
attributes are located.
6. To set the channel levels of another fixture, select the fixture with the
[+] or [–] keys.
7. Repeat steps 1 through 6 until finished with all fixtures.
9.
Pan and tilt are always selected together when either is selected.
Whichever of these two attributes is selected is placed on the Y-
wheel. The other is placed on the X-wheel.
82 Chapter 6 Adding moving lights to the show