Expression 3 - ETC

Submaster LEDs
Each submaster bump button contains one or two LEDs. The color and
state of the LED indicates the current state of that submaster, as shown
in the chart below:
Color State Meaning
–– Off Submaster not loaded.
Green Solid Submaster (pile-on or effect) loaded.
Green Slow Blink New pile-on or effect submaster. Loads when
slider reaches home position.
Green Fast Blink Submaster (pile-on or effect) on timed hold. Press
bump button to begin downfade.
Red Solid Inhibitive submaster loaded.
Red Slow Blink New submaster is an inhibitive submaster. Loads
when slider reaches home position.
Red Fast Blink Inhibitive submaster on timed hold. Press bump
button to begin downfade.
If the LED on a slider is blinking slowly, it means that you have changed
pages and a new submaster is waiting to load. The old submaster stays
loaded until you move the slider to the home position. If the green LED is
blinking, move the slider to zero. If the red LED is blinking, move the slider
to 10. If the submasters are changing type, you may need to do both.
When the slider reaches home, the channel levels from the new page
replace the old levels.
Note: If a submaster slider has both a submaster loading and a submaster
on hold, the submaster on hold takes priority and the LED blinks fast.
Press the bump button to downfade the old submaster.
Expression 3 User Manual, v.3.1 163