Expression 3 - ETC

Submaster pages
Expression 3 has ten pages of submasters. A page is a block of console
memory that contains one set of 24 recorded submasters, corresponding
to the 24 submaster sliders. The ten pages of memory increases the
number of possible submasters to 240.
The console displays the message Sub page 1 (2, 3...) in the upper right
corner of the Playback display to indicate the current submaster page. To
switch from one page to the other, press [Page], enter the desired page
number, and press [Enter].
When you switch submaster pages, any submasters on stage remain on
stage until you move their sliders to the home position. Until the new
submaster loads, submaster LEDs flash slowly, indicating that the
submaster on stage is from the previously loaded page. If flashing red, the
new submaster is inhibitive; if green, the new submaster is pile-on or an
effect. When you move the slider to its home position the new submaster
is loaded and the LED stops flashing. This prevents the stage from going
black or changing levels when you switch pages. (Fast flashes designate
a submaster with a dwell time of Hold. See Submaster LEDs, page 163
for more information about LEDs.)
Note: When you read a new show into the console from a disk, the
console loads the same page number that was loaded from the previous
show. Any submasters on stage when you read a new show into the
console remain on stage until you move their sliders to the home position.
Until the new submaster loads, submaster LEDs flash, indicating that the
submaster on stage is from the previously loaded show. If flashing red,
the new submaster is inhibitive; if green, the new submaster is pile-on or
an effect. When you move the slider to its home position the new
submaster is loaded and the LED stops flashing.
160 Chapter 13 Submasters