Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

Chapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS Commandscluster discovery hop-countcluster discovery hop-countUse the cluster discovery hop-count global configuration command on the switch stack or on the clustercommand switch to set the hop-count limit for extended discovery of candidate switches. Use the no formof this command to return to the default setting.cluster discovery hop-count numberno cluster discovery hop-countSyntax DescriptionnumberNumber of hops from the cluster edge that the cluster command switch limitsthe discovery of candidates. The range is 1 to 7.Defaults The hop count is set to 3.Command ModesGlobal configurationCommand HistoryRelease12.2(35)SE2ModificationThis command was introduced.Usage GuidelinesThis command is available only on the cluster command switch stack or cluster command switch. Thiscommand does not operate on cluster member switches.If the hop count is set to 1, it disables extended discovery. The cluster command switch discovers onlycandidates that are one hop from the edge of the cluster. The edge of the cluster is the point between thelast discovered cluster member switch and the first discovered candidate switch.ExamplesThis example shows how to set hop count limit to 4. This command is executed on the cluster commandswitch.Switch(config)# cluster discovery hop-count 4You can verify your setting by entering the show cluster privileged EXEC command.Related CommandsCommandshow clustershow cluster candidatesDescriptionDisplays the cluster status and a summary of the cluster to which theswitch belongs.Displays a list of candidate switches.OL-9776-08Catalyst 3750-E and 3560-E Switch Command Reference2-113