Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

dot1x reauthenticationChapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS Commandsdot1x reauthenticationUse the dot1x reauthentication interface configuration command on the switch stack or on a standaloneswitch to enable periodic re-authentication of the client. Use the no form of this command to return tothe default setting.dot1x reauthenticationno dot1x reauthenticationSyntax DescriptionThis command has no arguments or keywords.DefaultsPeriodic re-authentication is disabled.Command ModesInterface configurationCommand HistoryRelease12.2(35)SE2ModificationThis command was introduced.Usage GuidelinesYou configure the amount of time between periodic re-authentication attempts by using the dot1xtimeout reauth-period interface configuration command.ExamplesThis example shows how to disable periodic re-authentication of the client:Switch(config-if)# no dot1x reauthenticationThis example shows how to enable periodic re-authentication and to set the number of seconds betweenre-authentication attempts to 4000 seconds:Switch(config-if)# dot1x reauthenticationSwitch(config-if)# dot1x timeout reauth-period 4000You can verify your settings by entering the show dot1x [interface interface-id] privileged EXECcommand.Related CommandsCommanddot1x re-authenticatedot1x timeout reauth-periodshow dot1x [interfaceinterface-id]DescriptionManually initiates a re-authentication of all IEEE 802.1x-enabledports.Sets the number of seconds between re-authentication attempts.Displays IEEE 802.1x status for the specified port.2-174Catalyst 3750-E and 3560-E Switch Command ReferenceOL-9776-08