Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

dot1x fallbackChapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS Commandsdot1x fallbackUse the dot1xfallback interface configuration command on the switch stack or on a standalone switchto configure a port to use web authentication as a fallback method for clients that do not supportIEEE 802.1x authentication. To return to the default setting, use the no form of this command.dot1x fallback fallback-profileno dot1x fallbackSyntax Descriptionfallback-profile Specify a fallback profile for clients that do not support IEEE 802.1xauthentication.DefaultsNo fallback is enabled.Command ModesInterface configurationCommand HistoryRelease12.2(35)SE2ModificationThis command was introduced.Usage GuidelinesYou must enter the dot1x port-control auto interface configuration command on a switch port beforeentering this command.ExamplesThis example shows how to specify a fallback profile to a switch port that has been configured forIEEE 802.1x authentication:Switch# configure terminalEnter configuration commands, one per line. End with CNTL/Z.Switch(config)# interface gigabitethernet1/0/3Switch(config-if)# dot1x fallback profile1Switch(config-fallback-profile)# exitSwitch(config)# endYou can verify your settings by entering the show dot1x [interface interface-id] privileged EXECcommand.Related CommandsCommandshow dot1x [interface interface-id]fallback profileip admissionip admission name proxy httpDescriptionDisplays IEEE 802.1x status for the specified port.Create a web authentication fallback profile.Enable web authentication on a portEnable web authentication globally on a switch2-160Catalyst 3750-E and 3560-E Switch Command ReferenceOL-9776-08