Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

epm access-controlChapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS Commandsepm access-controlUse the epm access-control global configuration command on the switch stack or on a standalone switchto confiture an open directive for ports that do not have an access control list (ACL) configured. Use theno form of this command or the default keyword to disable the open directive.epm access-control{default | open}no access-control{default | open}Syntax DescriptiondefaultopenApply the policies of the static ACL configured on a port. If no static ACL isconfigured, this directive has the same effect as the open keyword.Allow traffic without a user profile to access the switch ports, without regard toother access policies.DefaultsThe default directive applies.Command ModesGlobal configurationCommand HistoryRelease12.2(35)SE212.2(55)SE2ModificationThis command was introduced.This command was introduced.Usage GuidelinesThis command allows hosts without a user profile to access ports whether a static ACL is configured onor not. When a static ACL is configured on a port, the open keyword is a directive to allow traffic withouta user profile to access the port, and the default keyword applies the policies of the ACL to the traffic.If no static ACL is configured on a port, both the default and open keywords allow access to the port.ExamplesThis example shows how to configure an open directive.Switch(config)# epm access-control openYou can verify your settings by entering the show running-config privileged EXEC command.Related CommandsCommandshow running-configDescriptionDisplays the operating configuration. For syntax information, use this link tothe Cisco IOS Release 12.2 Command Reference listing page:http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_command_reference_list.htmlSelect the Cisco IOS Commands Master List, Release 12.2 to navigate tothe command.2-184Catalyst 3750-E and 3560-E Switch Command ReferenceOL-9776-08