Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

mac address-table staticChapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS Commandsmac address-table staticUse the mac address-table static global configuration command on the switch stack or on a standaloneswitch to add static addresses to the MAC address table. Use the no form of this command to removestatic entries from the table.mac address-table static mac-addr vlan vlan-id interface interface-idno mac address-table static mac-addr vlan vlan-id [interface interface-id]Syntax Descriptionmac-addrvlan vlan-idinterface interface-idDestination MAC address (unicast or multicast) to add to the addresstable. Packets with this destination address received in the specifiedVLAN are forwarded to the specified interface.Specify the VLAN for which the packet with the specified MAC addressis received. The range is 1 to 4094.Interface to which the received packet is forwarded. Valid interfacesinclude physical ports and port channels.DefaultsNo static addresses are configured.Command ModesGlobal configurationCommand HistoryRelease12.2(35)SE2ModificationThis command was introduced.ExamplesThis example shows how to add the static address c2f3.220a.12f4 to the MAC address table. When apacket is received in VLAN 4 with this MAC address as its destination, the packet is forwarded to thespecified interface:Switch(config)# mac address-table static c2f3.220a.12f4 vlan 4 interfacegigabitethernet6/0/1You can verify your setting by entering the show mac address-table privileged EXEC command.Related CommandsCommandshow mac address-table staticDescriptionDisplays static MAC address table entries only.2-342Catalyst 3750-E and 3560-E Switch Command ReferenceOL-9776-08