Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

Chapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS Commandsdot1x defaultdot1x defaultUse the dot1x default interface configuration command on the switch stack or on a standalone switchto reset the IEEE 802.1x parameters to their default values.dot1x defaultSyntax DescriptionThis command has no arguments or keywords.DefaultsThese are the default values:• The per-port IEEE 802.1x protocol enable state is disabled (force-authorized).• The number of seconds between re-authentication attempts is 3600 seconds.• The periodic re-authentication is disabled.• The quiet period is 60 seconds.• The retransmission time is 30 seconds.• The maximum retransmission number is 2 times.• The host mode is single host.• The client timeout period is 30 seconds.• The authentication server timeout period is 30 seconds.Command ModesInterface configurationCommand HistoryRelease12.2(35)SE2ModificationThis command was introduced.ExamplesThis example shows how to reset the IEEE 802.1x parameters on a port:Switch(config-if)# dot1x defaultYou can verify your settings by entering the show dot1x [interface interface-id] privileged EXECcommand.Related CommandsCommandshow dot1x [interface interface-id]DescriptionDisplays IEEE 802.1x status for the specified port.OL-9776-08Catalyst 3750-E and 3560-E Switch Command Reference2-159