Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

ip igmp filterChapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS Commandsip igmp filterUse the ip igmp filter interface configuration command on the switch stack or on a standalone switchto control whether or not all hosts on a Layer 2 interface can join one or more IP multicast groups byapplying an Internet Group Management Protocol (IGMP) profile to the interface. Use the no form ofthis command to remove the specified profile from the interface.ip igmp filter profile numberno ip igmp filterSyntax Descriptionprofile number The IGMP profile number to be applied. The range is 1 to 4294967295.DefaultsNo IGMP filters are applied.Command ModesInterface configurationCommand HistoryRelease12.2(35)SE2ModificationThis command was introduced.Usage GuidelinesYou can apply IGMP filters only to Layer 2 physical interfaces; you cannot apply IGMP filters to routedports, switch virtual interfaces (SVIs), or ports that belong to an EtherChannel group.An IGMP profile can be applied to one or more switch port interfaces, but one port can have only oneprofile applied to it.ExamplesThis example shows how to apply IGMP profile 22 to a port:Switch(config)# interface gigabitethernet1/0/2Switch(config-if)# ip igmp filter 22You can verify your setting by using the show running-config privileged EXEC command and byspecifying an interface.Related CommandsCommandip igmp profileshow ip dhcp snoopingstatisticsDescriptionConfigures the specified IGMP profile number.Displays the characteristics of the specified IGMP profile.2-248Catalyst 3750-E and 3560-E Switch Command ReferenceOL-9776-08