Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

ip igmp snooping vlan staticChapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS Commandsip igmp snooping vlan staticUse the ip igmp snooping static global configuration command on the switch stack or on a standaloneswitch to enable Internet Group Management Protocol (IGMP) snooping and to statically add a Layer 2port as a member of a multicast group. Use the no form of this command to remove ports specified asmembers of a static multicast group.ip igmp snooping vlan vlan-id static ip-address interface interface-idno ip igmp snooping vlan vlan-id static ip-address interface interface-idSyntax Descriptionvlan-id Enable IGMP snooping on the specified VLAN. The range is 1 to 1001and 1006 to 4094.ip-addressinterface interface-idAdd a Layer 2 port as a member of a multicast group with the specified groupIP address.Specify the interface of the member port. The keywords have thesemeanings:• gigabitethernet interface number—a Gigabit Ethernet IEEE 802.3zinterface.• tengigabitethernet interface number—a 10-Gigabit EthernetIEEE 802.3z interface.• port-channel interface number—a channel interface. The range is 0to 48.DefaultsBy default, there are no ports statically configured as members of a multicast group.Command ModesGlobal configurationCommand HistoryRelease12.2(35)SE2ModificationThis command was introduced.Usage GuidelinesVLAN IDs 1002 to 1005 are reserved for Token Ring and FDDI VLANs and cannot be used in IGMPsnooping.The configuration is saved in NVRAM.ExamplesThis example shows how to statically configure a host on an interface:Switch(config)# ip igmp snooping vlan 1 static 0100.5e02.0203 interfacegigabitethernet1/0/1Configuring port gigabitethernet1/0/1 on group 0100.5e02.0203You can verify your settings by entering the show ip igmp snooping privileged EXEC command.2-268Catalyst 3750-E and 3560-E Switch Command ReferenceOL-9776-08