Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

eloadChapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS CommandsreloadUse the reload privileged EXEC command to reload the stack member and to put a configuration changeinto effect.reload [LINE | at | cancel | in | slot stack-member-number | standby-cpu]NoteThis command is supported only on Catalyst 3750-E switches.Syntax DescriptionLINEatcancelinslot stack-member-numberstandby-cpuSpecify the reason for the reload.Specify the time in hh:mm for the reload to occur.Cancel the pending reload.Specify a time interval in mmm or hhh:mm for reloads to occur.Save the changes on the specified stack member and restart it.Reload the standby route processor (RP).DefaultsImmediately reloads the stack member and puts a configuration change into effect.Command ModesPrivilege EXECCommand HistoryRelease12.2(35)SE2ModificationThis command was introduced.Usage GuidelinesIf there is more than one switch in the switch stack, and you enter the reload slot stack-member-numbercommand, you are not prompted to save the configuration.ExamplesThis example shows how to reload the switch stack:Switch(config)# reloadSystem configuration has been modified. Save? [yes/no]: yProceed to reload the whole Stack? [confirm] yThis example shows how to reload a specific stack member:Switch(config)# reload slot 6Proceed with reload? [confirm] yThis example shows how to reload a single-switch switch stack (there is only one member switch):Switch(config)# reload slot 3System configuration has been modified. Save? [yes/no]: yProceed to reload the whole Stack? [confirm] y2-462Catalyst 3750-E and 3560-E Switch Command ReferenceOL-9776-08