Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

Chapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS Commandsboot auto-copy-swboot auto-copy-swUse the boot auto-copy-sw global configuration command from the stack master to enable the automaticupgrade (auto-upgrade) process. It automatically upgrades a switch in version-mismatch (VM) mode bycopying the running software image on any stack member or by copying a tar file image in switch stackflash memory. Use the no form of this command to disable the auto-upgrade process.boot auto-copy-swno boot auto-copy-swNoteThis command is supported only on Catalyst 3750-E switches.Syntax DescriptionThis command has no arguments or keywords.DefaultsEnabled.Command ModesGlobal configurationCommand HistoryRelease12.2(35)SE2ModificationThis command was introduced.Usage GuidelinesA switch in VM mode is a switch that has a different minor version number than the version on the switchstack. A switch in VM mode cannot join the switch stack as a fully functioning member. If the switchstack has an image that can be copied to a switch in VM mode, the auto-upgrade process automaticallycopies the image from a stack member to the switch in VM mode. The switch then exits VM mode,reboots, and joins the switch stack as a fully functioning member.The auto-upgrade process affects only switches in VM mode. It does not affect existing stack members.Related CommandsCommandshow bootshow versionDescriptionDisplays the settings of the boot environment variables.Displays version information for the hardware and firmware.OL-9776-08Catalyst 3750-E and 3560-E Switch Command Reference2-65