Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

Chapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS Commandsauthentication host-modeThis example shows how to enable single-host mode on a port:Switch(config-if)# authentication host-mode single-hostYou can verify your settings by entering the show authentication privileged EXEC command.Related Commands Command Descriptionauthentication Configures the port mode as unidirectional or bidirectional.control-directionauthentication event Sets the action for specific authentication events.authenticationfallbackauthentication openauthentication orderauthenticationperiodicauthenticationport-controlauthenticationpriorityauthentication timerauthenticationviolationshow authenticationConfigures a port to use web authentication as a fallback method for clientsthat do not support IEEE 802.1x authenticationEnables or disable open access on a port.Sets the order of authentication methods used on a port.Enables or disable reauthentication on a port.Enables manual control of the port authorization state.Adds an authentication method to the port-priority list.Configures the timeout and reauthentication parameters for an802.1x-enabled port.Configures the violation modes that occur when a new device connects to aport or when a new device connects to a port after the maximum number ofdevices are connected to that port.Displays information about authentication manager events on the switch.OL-9776-08Catalyst 3750-E and 3560-E Switch Command Reference2-33