Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

cluster enableChapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS Commandscluster enableUse the cluster enable global configuration command on a command-capable switch or switch stack toenable it as the cluster command switch, assign a cluster name, and to optionally assign a membernumber to it. Use the no form of the command to remove all members and to make the cluster commandswitch a candidate switch.cluster enable name [command-switch-member-number]no cluster enableSyntax Descriptionnamecommand-switch-member-numberName of the cluster up to 31 characters. Valid characters includeonly alphanumerics, dashes, and underscores.(Optional) Assign a member number to the cluster commandswitch of the cluster. The range is 0 to 15.DefaultsThe switch is not a cluster command switch.No cluster name is defined.The member number is 0 when the switch is the cluster command switch.Command ModesGlobal configurationCommand HistoryRelease12.2(35)SE2ModificationThis command was introduced.Usage GuidelinesEnter this command on any command-capable switch that is not part of any cluster. This command failsif a device is already configured as a member of the cluster.You must name the cluster when you enable the cluster command switch. If the switch is alreadyconfigured as the cluster command switch, this command changes the cluster name if it is different fromthe previous cluster name.ExamplesThis example shows how to enable the cluster command switch, name the cluster, and set the clustercommand switch member number to 4.Switch(config)# cluster enable Engineering-IDF4 4You can verify your setting by entering the show cluster privileged EXEC command on the clustercommand switch.2-114Catalyst 3750-E and 3560-E Switch Command ReferenceOL-9776-08