Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

cluster runChapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS Commandscluster runUse the cluster run global configuration command to enable clustering on a switch. Use the no form ofthis command to disable clustering on a switch.cluster runno cluster runSyntax DescriptionThis command has no arguments or keywords.DefaultsClustering is enabled on all switches.Command ModesGlobal configurationCommand HistoryRelease12.2(35)SE2ModificationThis command was introduced.Usage GuidelinesWhen you enter the no cluster run command on a cluster command switch or cluster command switchstack, the cluster command switch is disabled. Clustering is disabled, and the switch cannot become acandidate switch.When you enter the no cluster run command on a cluster member switch, it is removed from the cluster.Clustering is disabled, and the switch cannot become a candidate switch.When you enter the no cluster run command on a switch that is not part of a cluster, clustering isdisabled on this switch. This switch cannot then become a candidate switch.ExamplesThis example shows how to disable clustering on the cluster command switch:Switch(config)# no cluster runYou can verify your setting by entering the show cluster privileged EXEC command.Related CommandsCommandshow clusterDescriptionDisplays the cluster status and a summary of the cluster to which the switchbelongs.2-120Catalyst 3750-E and 3560-E Switch Command ReferenceOL-9776-08