Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

license bootChapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS Commandslicense bootUse the license boot global configuration command to configure the switch to use a specific softwarelicense. Use the no form of this command to configure the switch to use the default hierarchy todetermine the software license to use.license boot level license-level [switch switch-number]no license boot level license-levelSyntax Descriptionlevel license-levelSpecify the software license level. -state group number. The onlylicense-level option is ipservices.switch switch-number (Optional) Specify the stack member. The range is from 1 to 9.This keyword is supported only on on stacking-capable switches.DefaultsThe switch uses the default hierarchy to determine the first software license to use.Command ModesGlobal configurationCommand HistoryRelease12.2(46)SEModificationThis command was introduced.Usage GuidelinesIf you do not enter the license boot command and more than one software license is installed on theswitch, this hierarchy determines the first software license to locate in the flash memory and install:1. IP services2. IP baseFor more information about using software licenses, see the Cisco IOS Software Activation document onCisco.com and the Cisco IOS Software Activation Configuration Guide, Release 12.4T at:http://www.cisco.com/en/US/docs/ios/csa/configuration/guide/12.4T/csa_book.htmlExamplesThis example shows how to configure the switch to use the advanced IP services feature set on stackmember 4:Switch(config)# license boot level advipservices switch 4You can verify your settings by entering the show license privileged EXEC command.2-316Catalyst 3750-E and 3560-E Switch Command ReferenceOL-9776-08