Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

errdisable recoveryChapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS Commandserrdisable recoveryUse the errdisable recovery global configuration command on the switch stack or on a standaloneswitch to configure the recover mechanism variables. Use the no form of this command to return to thedefault setting.errdisable recovery {cause {all | arp-inspection | bpduguard | channel-misconfig |dhcp-rate-limit | dtp-flap | gbic-invalid | inline-power | l2ptguard | link-flap | loopback |pagp-flap | psecure-violation | security-violation | sfp-mismatch | udld | vmps}} | {intervalinterval}no errdisable recovery {cause {all | arp-inspection | bpduguard | channel-misconfig |dhcp-rate-limit | dtp-flap | gbic-invalid | inline-power | l2ptguard | link-flap | loopback |pagp-flap | psecure-violation | security-violation | sfp-mismatch | udld | vmps}}| {intervalinterval}Syntax Description cause Enable the error-disabled mechanism to recover from a specific cause.allEnable the timer to recover from all error-disabled causes.bpduguardEnable the timer to recover from the bridge protocol data unit (BPDU) guarderror-disabled state.arp-inspection Enable the timer to recover from the Address Resolution Protocol (ARP)inspection error-disabled state.channel-misconfig Enable the timer to recover from the EtherChannel misconfigurationerror-disabled state.dhcp-rate-limit Enable the timer to recover from the DHCP snooping error-disabled state.dtp-flapEnable the timer to recover from the Dynamic Trunking Protocol (DTP) flaperror-disabled state.gbic-invalidEnable the timer to recover from an invalid Gigabit Interface Converter(GBIC) module error-disabled state.inline-powerl2ptguardlink-flaploopbackpagp-flappsecure-violationsecurity-violationsfp-config-mismatchudldNoteThis error refers to an invalid small form-factor pluggable (SFP)error-disabled state.Enable the timer to recover from the Power over Ethernet (PoE) error-disabledstate.This keyword is supported only on switches with PoE ports.Enable the timer to recover from a Layer 2 protocol tunnel error-disabledstate.Enable the timer to recover from the link-flap error-disabled state.Enable the timer to recover from a loopback error-disabled state.Enable the timer to recover from the Port Aggregation Protocol (PAgP)-flaperror-disabled state.Enable the timer to recover from a port security violation disable state.Enable the timer to recover from an IEEE 802.1x-violation disabled state.Enable error detection on an SFP configuration mismatch.Enable the timer to recover from the UniDirectional Link Detection (UDLD)error-disabled state.2-190Catalyst 3750-E and 3560-E Switch Command ReferenceOL-9776-08