Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

interface port-channelChapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS CommandsFollow these guidelines when you use the interface port-channel command:• If you want to use the Cisco Discovery Protocol (CDP), you must configure it only on the physicalport and not on the port-channel interface.• Do not configure a port that is an active member of an EtherChannel as an IEEE 802.1x port. IfIEEE 802.1x is enabled on a not-yet active port of an EtherChannel, the port does not join theEtherChannel.For a complete list of configuration guidelines, see the “Configuring EtherChannels” chapter in thesoftware configuration guide for this release.Examples This example shows how to create a port-channel interface with a port channel number of 5:Switch(config)# interface port-channel 5You can verify your setting by entering the show running-config privileged EXEC or showetherchannel channel-group-number detail privileged EXEC command.Related Commands Command Descriptionchannel-group Assigns an Ethernet port to an EtherChannel group.show etherchannel Displays EtherChannel information for a channel.show running-config Displays the operating configuration. For syntax information, use this link tothe Cisco IOS Release 12.2 Command Reference listing page:http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_command_reference_list.htmlSelect the Cisco IOS Commands Master List, Release 12.2 to navigate tothe command.2-202Catalyst 3750-E and 3560-E Switch Command ReferenceOL-9776-08