Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

Chapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS Commandscluster outside-interfacecluster outside-interfaceUse the cluster outside-interface global configuration command on the switch stack or on the a clustercommand switch to configure the outside interface for cluster Network Address Translation (NAT) so thata member without an IP address can communicate with devices outside the cluster. Use the no form ofthis command to return to the default setting.cluster outside-interface interface-idno cluster outside-interfaceSyntax Descriptioninterface-idInterface to serve as the outside interface. Valid interfaces includephysical interfaces, port-channels, or VLANs. The port-channelrange is 1 to 48. The VLAN range is 1 to 4094.DefaultsThe default outside interface is automatically selected by the cluster command switch.Command ModesGlobal configurationCommand HistoryRelease12.2(35)SE2ModificationThis command was introduced.Usage GuidelinesEnter this command only on the cluster command switch. If you enter this command on a cluster memberswitch, an error message appears.Examples This example shows how to set the outside interface to VLAN 1:Switch(config)# cluster outside-interface vlan 1You can verify your setting by entering the show running-config privileged EXEC command.Related CommandsCommandshow running-configDescriptionDisplays the operating configuration. For syntax information, use thislink to the Cisco IOS Release 12.2 Command Reference listing page:http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_command_reference_list.htmlSelect the Cisco IOS Commands Master List, Release 12.2 tonavigate to the command.OL-9776-08Catalyst 3750-E and 3560-E Switch Command Reference2-119