Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

Chapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS Commandsdiagnostic startdiagnostic startUse the diagnostic start privileged EXEC command to run an online diagnostic test.diagnostic start switch number test {name | test-id | test-id-range | all | basic | non-disruptive}Syntax Descriptionswitch numbertestnametest-idtest-id-rangeallbasicnon-disruptiveSpecify the switch number, which is the stack member number. If theswitch is a standalone switch, the switch number is 1. If the switch is in astack, the range is 1 to 9, depending on the switch member numbers in thestack.This keyword is supported only on on stacking-capable switches.Specify the tests to run.Specify the name of a test. For more information, see the “UsageGuidelines” section.Specify the ID number of a test. The range is from 1 to 7. For moreinformation, see the “Usage Guidelines” section.Specify more than one test with the range of test ID numbers. For moreinformation, see the “Usage Guidelines” section.Specify all the diagnostic tests.Specify the basic on-demand diagnostic tests.Specify the nondisruptive health-monitoring tests.DefaultsThis command has no default setting.Command ModesPrivileged EXECCommand HistoryRelease12.2(35)SE2ModificationThis command was introduced.Usage GuidelinesThe switch supports these tests:ID Test Name [On-Demand Test Attributes]--- -------------------------------------------1 TestPortAsicStackPortLoopback [B*N****]2 TestPortAsicLoopback [B*D*R**]3 TestPortAsicCam [B*D*R**]4 TestPortAsicRingLoopback [B*D*R**]5 TestMicRingLoopback [B*D*R**]6 TestPortAsicMem [B*D*R**]7 TestInlinePwrCtlr [B*D*R**]--- -------------------------------------------OL-9776-08Catalyst 3750-E and 3560-E Switch Command Reference2-143