Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

ip arp inspection vlan loggingChapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS Commandsip arp inspection vlan loggingUse the ip arp inspection vlan logging global configuration command on the switch stack or on astandalone switch to control the type of packets that are logged per VLAN. Use the no form of thiscommand to disable this logging control.ip arp inspection vlan vlan-range logging {acl-match {matchlog | none} | dhcp-bindings {all |none | permit} | arp-probe}no ip arp inspection vlan vlan-range logging {acl-match | dhcp-bindings | arp-probe}This command is available only if your switch is running the IP services feature set.Syntax Descriptionvlan-rangeacl-match {matchlog |none}dhcp-bindings{permit | all | none}arp-probeSpecify the VLANs configured for logging.You can specify a single VLAN identified by VLAN ID number, a range ofVLANs separated by a hyphen, or a series of VLANs separated by a comma.The range is 1 to 4094.Specify that the logging of packets is based on access control list (ACL)matches.The keywords have these meanings:• matchlog—Log packets based on the logging configuration specified inthe access control entries (ACE). If you specify the matchlog keyword inthis command and the log keyword in the permit or deny ARP access-listconfiguration command, Address Resolution Protocol (ARP) packetspermitted or denied by the ACL are logged.• none—Do not log packets that match ACLs.Specify the logging of packets is based on Dynamic Host ConfigurationProtocol (DHCP) binding matches.The keywords have these meanings:• all—Log all packets that match DHCP bindings.• none—Do not log packets that match DHCP bindings.• permit—Log DHCP-binding permitted packets.Specify logging of packets permitted specifically because they are ARPprobes.DefaultsAll denied or all dropped packets are logged. ARP probe packets are not logged.Command ModesGlobal configurationCommand HistoryRelease12.2(35)SE212.2(37)SEModificationThis command was introduced.The arp-probe keyword was added.2-226Catalyst 3750-E and 3560-E Switch Command ReferenceOL-9776-08