Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

ip verify sourceChapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS CommandsSwitch# show ip verify source interface fastethernet0/1Interface Filter-type Filter-mode IP-address Mac-address Vlan--------- ----------- ----------- --------------- ----------------- ----------Gi1/0/1 ip-mac active 10.0.0.1 10Gi1/0/1 ip-mac active deny-all 11-20Switch#This example shows how to enable IP port security with IP-MAC filters on a Layer 2 access port:Switch# configure terminalEnter configuration commands, one per line. End with CNTL/Z.Switch(config)# ip device trackingSwitch(config)# interface gigabitethernet1/0/3Switch(config-if)# switchport mode accessSwitch(config-if)# switchport access vlan 1Switch(config-if)# ip device tracking maximum 5Switch(config-if)# switchport port-securitySwitch(config-if)# switchport port-security maximum 5Switch(config-if)# ip verify source tracking port-securitySwitch(config-if)# endVerify your settings by entering the show ip verify source privileged EXEC command.Related Commands Command Descriptionip device tracking maximum Enable IP port security binding tracking on a Layer 2 port.ip dhcp snoopingGlobally enable DHCP snooping.ip dhcp snooping limit rate Configure the number of the DHCP messages that an interfacecan receive per second.ip dhcp snooping information Enable DHCP option-82 data insertion.optionip dhcp snooping trustEnable DHCP snooping on a trusted VLAN.ip source bindingConfigure static bindings on the switch.show ip dhcp snoopingDisplay the DHCP snooping configuration.show ip dhcp snooping binding Display the DHCP snooping binding entries.show ip verify sourceDisplay the IP source guard configuration on the switch or on aspecific interface.2-280Catalyst 3750-E and 3560-E Switch Command ReferenceOL-9776-08