Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

commandChapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS CommandsrcommandUse the rcommand user EXEC command on the switch stack or on the cluster command switch to start aTelnet session and to execute commands on a cluster member switch from the cluster command switchor the switch stack. To end the session, enter the exit command.rcommand {n | commander | mac-address hw-addr}Syntax Descriptionn Provide the number that identifies a cluster member. The range is 0 to 15.commanderProvide access to the cluster command switch from a cluster memberswitch.mac-address hw-addr MAC address of the cluster member switch.Command ModesUser EXECCommand HistoryRelease12.2(35)SE2ModificationThis command was introduced.Usage GuidelinesThis command is available only on the cluster command switch stack or cluster command switch.If the switch is the cluster command switch but the cluster member switch n does not exist, an errormessage appears. To get the switch number, enter the show cluster members privileged EXECcommand on the cluster command switch.You can use this command to access a cluster member switch from the cluster command-switch promptor to access a cluster command switch from the member-switch prompt.For Catalyst 2940, 2950, 2960, 2970, 3550, 3560, 3560-E, 3750, and 3750-E switches, the Telnet sessionaccesses the member-switch command-line interface (CLI) at the same privilege level as on the clustercommand switch. For example, if you execute this command at user level on the cluster commandswitch, the cluster member switch is accessed at user level. If you use this command on the clustercommand switch at privileged level, the command accesses the remote device at privileged level. If youuse an intermediate enable-level lower than privileged, access to the cluster member switch is at userlevel.For Catalyst 1900 and 2820 switches running standard edition software, the Telnet session accesses themenu console (the menu-driven interface) if the cluster command switch is at privilege level 15. If thecluster command switch is at privilege level 1, you are prompted for the password before being able toaccess the menu console. Cluster command switch privilege levels map to the cluster member switchesrunning standard edition software as follows:• If the cluster command switch privilege level is from 1 to 14, the cluster member switch is accessedat privilege level 1.• If the cluster command switch privilege level is 15, the cluster member switch is accessed atprivilege level 15.2-460Catalyst 3750-E and 3560-E Switch Command ReferenceOL-9776-08