Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

interface rangeChapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS Commands• tengigabitethernet stack member/module/{first port} - {last port}, where module is always 0For physical interfaces:– stack member is the number used to identify the switch within the stack. The number rangesfrom 1 to 9 and is assigned to the switch the first time the stack member initializes.– module is always 0– the range is type stack member/0/number - number (for example, gigabitethernet1/0/1 - 2)• port-channel port-channel-number - port-channel-number, where port-channel-number is from 1to 48NoteWhen you use the interface range command with port channels, the first and last portchannel number in the range must be active port channels.When you define a range, you must enter a space between the first entry and the hyphen (-):interface range gigabitethernet1/0/1 -2When you define multiple ranges, you must still enter a space after the first entry and before thecomma (,):interface range gigabitethernet1/0/1 - 2, gigabitethernet1/0/1 - 2You cannot specify both a macro and an interface range in the same command.You can also specify a single interface in port-range. The command is then similar to the interfaceinterface-id global configuration command.For more information about configuring interface ranges, see the software configuration guide for thisrelease.ExamplesThis example shows how to use the interface range command to enter interface-range configurationmode to apply commands to two ports:Switch(config)# interface range gigabitethernet1/0/1 - 2Switch(config-if-range)#This example shows how to use a port-range macro macro1 for the same function. The advantage is thatyou can reuse macro1 until you delete it.Switch(config)# define interface-range macro1 gigabitethernet1/0/1 - 2Switch(config)# interface range macro macro1Switch(config-if-range)#Related Commands Command Descriptiondefine interface-range Creates an interface range macro.show running-config Displays the operating configuration. For syntax information, use this linkto the Cisco IOS Release 12.2 Command Reference listing page:http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_command_reference_list.htmlSelect the Cisco IOS Commands Master List, Release 12.2 to navigate tothe command.2-204Catalyst 3750-E and 3560-E Switch Command ReferenceOL-9776-08