Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

power inlineChapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS CommandsThis example shows how to configure a PoE port on a switch to allow a class 1 or a class 2 powereddevice:Switch(config)# interface gigabitethernet1/0/2Switch(config-if)# power inline auto max 7000This example shows how to disable powered-device detection and to not power a PoE port on a switch:Switch(config)# interface gigabitethernet1/0/2Switch(config-if)# power inline neverThis example shows how to configure a port to supply 20 W to an attached device:Switch(config-if)# power inline port maximum 20000You can verify your settings by entering the show power inline user EXEC command.Related Commands Command Descriptionlogging event Enables the logging of PoE events.power-inline-statusshow controllers Displays the values in the registers of the specified PoE controller.power inlineshow power inline Displays the PoE status for the specified PoE port or for all PoE ports.2-438Catalyst 3750-E and 3560-E Switch Command ReferenceOL-9776-08