11.07.2015 Views

Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

ip igmp snooping last-member-query-intervalChapter 2<strong>Catalyst</strong> <strong>3750</strong>-E <strong>and</strong> <strong>3560</strong>-E <strong>Switch</strong> <strong>Cisco</strong> <strong>IOS</strong> Comm<strong>and</strong>sip igmp snooping last-member-query-intervalUse the ip igmp snooping last-member-query-interval global configuration comm<strong>and</strong> on the switchstack or on a st<strong>and</strong>alone switch to enable the Internet Group Management Protocol (IGMP)configurable-leave timer globally or on a per-VLAN basis. Use the no form of this comm<strong>and</strong> to returnto the default setting.ip igmp snooping [vlan vlan-id] last-member-query-interval timeno ip igmp snooping [vlan vlan-id] last-member-query-intervalSyntax Descriptiontvlan vlan-idtime(Optional) Enable IGMP snooping <strong>and</strong> the leave timer on the specifiedVLAN. The range is 1 to 1001 <strong>and</strong> 1006 to 4094.Interval time out in seconds. The range is 100 to 32768 milliseconds.DefaultsThe default timeout setting is 1000 milliseconds.Comm<strong>and</strong> ModesGlobal configurationComm<strong>and</strong> HistoryRelease12.2(35)SE212.2(46)SEModificationThis comm<strong>and</strong> was introduced.The range for time was modified to 0 to 32768 milliseconds.Usage GuidelinesWhen IGMP snooping is globally enabled, IGMP snooping is enabled on all the existing VLANinterfaces. When IGMP snooping is globally disabled, IGMP snooping is disabled on all the existingVLAN interfaces.VLAN IDs 1002 to 1005 are reserved for Token Ring <strong>and</strong> FDDI VLANs <strong>and</strong> cannot be used in IGMPsnooping.Configuring the leave timer on a VLAN overrides the global setting.The IGMP configurable leave time is only supported on devices running IGMP Version 2.The configuration is saved in NVRAM.ExamplesThis example shows how to globally enable the IGMP leave timer for 2000 milliseconds:<strong>Switch</strong>(config)# ip igmp snooping last-member-query-interval 2000This example shows how to configure the IGMP leave timer for 3000 milliseconds on VLAN 1:<strong>Switch</strong>(config)# ip igmp snooping vlan 1 last-member-query-interval 3000You can verify your settings by entering the show ip igmp snooping privileged EXEC comm<strong>and</strong>.2-256<strong>Catalyst</strong> <strong>3750</strong>-E <strong>and</strong> <strong>3560</strong>-E <strong>Switch</strong> Comm<strong>and</strong> ReferenceOL-9776-08

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!