Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

Chapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS Commandspermit (MAC access-list configuration)lsap lsap-number mask (Optional) Use the LSAP number (0 to 65535) of a packet with 802.2encapsulation to identify the protocol of the packet.The mask is a mask of don’t care bits applied to the LSAP number beforetesting for a match.mop-console(Optional) Select EtherType DEC-MOP Remote Console.mop-dump(Optional) Select EtherType DEC-MOP Dump.msdos(Optional) Select EtherType DEC-MSDOS.mumps(Optional) Select EtherType DEC-MUMPS.netbiosvines-echovines-ipxns-idp(Optional) Select EtherType DEC- Network Basic Input/Output System(NETBIOS).(Optional) Select EtherType Virtual Integrated Network Service (VINES)Echo from Banyan Systems.(Optional) Select EtherType VINES IP.(Optional) Select EtherType Xerox Network Systems (XNS) protocolsuite.To filter IPX traffic, you use the type mask or lsap lsap mask keywords, depending on the type of IPXencapsulation being used. Filter criteria for IPX encapsulation types as specified in Novell terminologyand Cisco IOS terminology are listed in Table 2-22.Table 2-22IPX Filtering CriteriaIPX Encapsulation TypeCisco IOS NameNovell NameFilter Criterionarpa Ethernet II Ethertype 0x8137snap Ethernet-snap Ethertype 0x8137sap Ethernet 802.2 LSAP 0xE0E0novell-ether Ethernet 802.3 LSAP 0xFFFFDefaultsThis command has no defaults. However, the default action for a MAC-named ACL is to deny.Command ModesMAC access-list configurationCommand HistoryRelease12.2(35)SE2ModificationThis command was introduced.OL-9776-08Catalyst 3750-E and 3560-E Switch Command Reference2-425