Catalyst 3750-E and 3560-E Switch Cisco IOS ... - DNIP . NET

monitor sessionChapter 2Catalyst 3750-E and 3560-E Switch Cisco IOS CommandsSyntax Description session_number Specify the session number identified with the SPAN or RSPAN session.The range is 1 to 66.destinationinterface interface-idencapsulation replicateingressdot1q vlan vlan-idisluntagged vlan vlan-idvlan vlan-idremote vlan vlan-iddestination-port group{a | b | c}Specify the SPAN or RSPAN destination. A destination must be a physicalport.Specify the destination or source interface for a SPAN or RSPAN session.Valid interfaces are physical ports (including type, stack member, module,and port number). For source interface, port channel is also a validinterface type, and the valid range is 1 to 48.(Optional) Specify that the destination interface replicates the sourceinterface encapsulation method. If not selected, the default is to sendpackets in native form (untagged).These keywords are valid only for local SPAN. For RSPAN, the RSPANVLAN ID overwrites the original VLAN ID; therefore, packets are alwayssent untagged.(Optional) Enable ingress traffic forwarding.Accept incoming packets with IEEE 802.1Q encapsulation with thespecified VLAN as the default VLAN.Specify ingress forwarding using ISL encapsulation.Accept incoming packets with untagged encapsulation with the specifiedVLAN as the default VLAN.When used with only the ingress keyword, set default VLAN for ingresstraffic.Specify the remote VLAN for an RSPAN source or destination session. Therange is 2 to 1001 and 1006 to 4094.The RSPAN VLAN cannot be VLAN 1 (the default VLAN) or VLAN IDs1002 to 1005 (reserved for Token Ring and FDDI VLANs).This option is only supported on the Catalyst 3560-E-12D aggregatorswitch.Specify the destination-port group to which the destination ports belong ifyou are configuring a RSPAN source session.The switch supports these destination-port groups depending on the switchport configuration:• a—tengigabitethernet 0/1 to tengigabitethernet 0/4 orgigabitethernet 0/1 to gigabitethernet 0/8• b—tengigabitethernet 0/5 to tengigabitethernet 0/8 orgigabitethernet 0/9 to gigabitethernet 0/16• c—tengigabitethernet 0/9 to tengigabitethernet 0/12 orgigabitethernet 0/17 to gigabitethernet 0/24, (Optional) Specify a series of interfaces or VLANs, or separate a range ofinterfaces or VLANs from a previous range. Enter a space before and afterthe comma.- (Optional) Specify a range of interfaces or VLANs. Enter a space beforeand after the hyphen.filter vlan vlan-id Specify a list of VLANs as filters on trunk source ports to limit SPANsource traffic to specific VLANs. The vlan-id range is 1 to 4094.2-390Catalyst 3750-E and 3560-E Switch Command ReferenceOL-9776-08