InterForm Manual - System & Method

Library list option How to build up the library list.
*JOBD will refer to the initial library list parameter, INLLIBL of the job
description used.
*CURRENT will use the same library list as the current job starting the
AFC job. The current job is AFCSTART when starting with the
subsystem, but if you start the job manually the library list may be
different so use this value with care...
Use spooled file code page
as job CCSID Normally the CCSID of the AFC jobs is the same as the system value
(with the value *NO) , but if you change the value from *NO (which is
default) into *YES the spooled file code page is used as the jobs
CCSID. This means that if you are running several codepages on the
same machine you can now let the user programs called by Auto
Forms Control run under the CCSID indicated by the spooled file that
triggered the call.
If you state *YES and the spooled file has no specific code page (e.g.
*DEVD) then the CCSID of the job is set to the code page specified for
the AFC output queue - refer to page 134 to see where it is set.
Separator drawer Sets the default separator drawer i.e. from what paper drawer in the
printer the separator page will be printed. This is activated via the
1=Merge with overlay command in AFC - if it has the value
*DEFAULT as the separator drawer - refer to page 145 for more
information. The separator page contains the following information:
Output from InterForm400 merge
Overlay name . . . . : IF400DEMO
File set . . . . . : SAMPLE
Primary / secondary . : *PRI
Copies . . . . . . . : 001
Input spooled file:
*.Jobname . . . . . . : QPADEV0002
*.Userprofile . . . . : KSE
*.Jobnumber . . . . . : 092247
*.Date . . . . . . . : 2001-04-25
*.Time . . . . . . . : 02:40:15
*.Filename . . . . . : QPRINT
*.Filenumber . . . . : 0004
*.Number of pages . . : 0000007
Kim Egekjaer
DBCS code page (Prompt with F4 to list valid DBCS codepages.) If any DBCS characters
is found in the spooled file then the code page specified here will be
used - unless the spooled file has a explicit DBCS code page then the
next value determines the code page to use:
When to use DBCS code page
Possible values are:
*SPLFATR: The DBCS code page above is always used for any DBCS
characters in the spooled files - unless the spooled file has a specific
DBCS code page specified in CHRID - then this is used instead.
*ALWAYS: The code page of the spooled file is ignored for DBCS
characters and the DBCS code page above is always used when a
DBCS spooled file is detected.
InterForm A/S 137