InterForm Manual - System & Method

DLTF FILE(QGPL/SAVF3812)
4. Start the upgrade or install via the command:
APF3812NEW/APF3812NEW
5. Skip the LODRUN instruction below but otherwise the rest of the installation
procedure is the same:
� TIP �
If you have a very limited bandwidth you can also consider to upload a zip file with the save
file within onto the System i and then unzip the file directly on the System i (with
apf3812/unzip) before you copy the SAVF3812 file into a save file (The save file must be
created before) with the command:
CPYFRMSTMF FROMSTMF('/pcdata/savf3812')
TOMBR('/qsys.lib/qgpl.lib/savf3812.file') MBROPT(*REPLACE)
CVTDTA(*NONE)
(Here we copy the file savf3812 in the IFS directory pcdata into a save file with the same name
in library qgpl).
Installing from a CD
®
Now you are ready to install the InterForm400 system from a CD-ROM.
Note: Refer to page 392 if you are performing the below steps as an upgrade to an existing
®
InterForm400 installation.
1. Insert the CD into the CD-ROM drive of your System i.
2. Enter the following CL command on a command line to install:
LODRUN DEV(Device)
Where Device is the name of the Device containing the media. (If you are using the
systems default CD-ROM drive you can use *OPT instead of the Device-parameter.)
3. At the first screen you are asked to confirm that you agree with the End User License
Agreement:
Accept InterForm400 End User License Agreement EUA200D
IMPORTANT: BY USING INTERFORM400 AND MODULES, YOU ARE AGREEING TO BE BOUND BY
THE FOLLOWING INTERFORM A/S TERMS.
InterForm A/S (Licensor)
END USER LICENSE AGREEMENT
Concerning the licensing of the Software InterForm400 and modules
(hereinafter referred to as "the Software").
Intellectual property rights
The Licensor holds the copyright and all other intellectual property rights
to the Software and all future versions and upgrades hereof.
The Licensee is not entitled to change or remove any notice on copyright,
trademarks or any other rights marked on the Software or the data media.
Scope of the license
F3=Exit F12=Cancel F16=Accept EULA
More...
Please notice, that there are more than this screen. Press the key to view the
other screens and press to accept this license agreement. After the installation/upgrade
InterForm A/S 27