InterForm Manual - System & Method

for each print job unless you use *CONTINUOUS - then
*CUTTER will cut out each label.
Labels / Continuous (MEDIATRACK):
Controls the feed of the labels on the printer. Select *LABELS
if the media contains of separate labels. select
*CONTINUOUS if the media is not separated into labels (in
this case you would probably select *CUTTER for the print
mode parameter). Other values are: *WEBLABEL
and *MARKLABEL - for various ways to mark the edge of a
label on the media.
Media type (MEDIATYPE):
� NOTE �
Select *TRANSFER if you use a non heat sensitive media
otherwise use *THERMAL.
Creation of ZPL output from InterForm400 requires the purchase of the ZPL module for
InterForm400.
The Print ASCII File Command
The APF3812/PRTASCF command prints a ASCII file to an output queue as a SCS spool file.
The ASCII file must be placed in IFS. The contents of the ASCII file must be PRTCTL(*FCFC),
which means the first character of each line is a control code for the printer. E.g. a ‘1' in
position 1 is specifying, that this line is to be printed as the first line of a new page. All other
lines must have a blank in this position.
This command can substitute the OS/400 commands: PRTASCSTMF and CVTPCLSPLF.
The input for CVTPCLSPLF and PRTASCF have to be symbol set ISO-8859-1 (Latin 1).
The Split Spooled File Command
The command APF3812/SPLITSPLF makes it possible to split an *SCS spooled file without
Auto Forms Control. You only identify the spooled file and an InterForm400 split definition:
Type choices, press Enter.
Split Spooled File (SPLITSPLF)
Split definition . . . . SPLITDEF __________ Name
Job Name . . . . . . . . JOB __________ Name, *
User Name . . . . . . __________ Name
Job Number . . . . . . ______ 000000-999999
Spooled File Name . . . FILE __________ Name
Spooled File Number . . SPLNBR *LAST 1-999999, *ONLY, *LAST
Bottom
F3=Exit F4=Prompt F5=Refresh F12=Cancel F13=How to use this display
F24=More keys
InterForm A/S 447