InterForm Manual - System & Method

Configure InterForm 400 APF101D
2/15
Specify default form type for the InterForm 400 system.
Users may override value when using the system.
Form type *STD______
Select paper size 4 1 = LETTER 5 = COM-10 A = LEDGER
2 = LEGAL 6 = MONARCH B = A3
3 = EXECUTIVE 7 = C5 C = A5
4 = A4 8 = DL
Do you want to define paper size on the individual overlays Y (Y N)
F3=Exit F12=Cancel
The specified type of forms will be used throughout the system unless you state Y to allow
individual paper size definitions for different overlays.
Note that the Paper size selection on the Design overlay menu (see screen with Global overlay
settings on page 49) will only appear if Y has been stated in this screen. If N is inserted all
overlays throughout the system will use the default paper size stated here.
Configure InterForm 400 APF101D
3/15
Number to be added to the macro numbers the system works with . . . ____0
The reason to add a number can be, that printers are equipped with
flash-simm cards, that does not correspond to the HP standard saying,
that a macro in the printers internal memory should be selected,
even if it has the same number as a macro in the flash-simm.
F3=Exit F12=Cancel
The next screen is a possibility of defining an offset to the macros generated by
®
InterForm400 .
®
InterForm400 will always load the overlay as a macro prior to the spool data for performance
reasons. The macro ID can in some rare cases conflict with resident macros installed in the
printer.
This default value of zero should normally not be touched.
InterForm A/S 287