InterForm Manual - System & Method

32 User’s Manual for InterForm400 ®
Configure InterForm 400 APF101D
2/15
Specify default form type for the InterForm 400 system.
Users may override value when using the system.
Form type *STD______
Select paper size 4 1 = LETTER 5 = COM-10 A = LEDGER
2 = LEGAL 6 = MONARCH B = A3
3 = EXECUTIVE 7 = C5 C = A5
4 = A4 8 = DL
Do you want to define paper size on the individual overlays Y (Y N)
F3=Exit F12=Cancel
Leave the macro offset value at “0". Refer to page 287 for additional info
Configure InterForm 400 APF101D
3/15
Number to be added to the macro numbers the system works with . . . ___0
The reason to add a number can be, that printers are equipped with
flash-simm cards, that does not correspond to the HP standard saying,
that a macro in the printers internal memory should be selected,
even if it has the same number as a macro in the flash-simm.
F3=Exit F12=Cancel
If you do not intend to exchange overlays between a number of InterForm400 ®
installations, you can answer N to using DDM. Refer to page 288 for more information
on using DDM.
Configure InterForm 400 APF101D
4/15
Do you want to use DDM to InterForm files
on other AS/400
Use DDM . . . . . . . Y (Y N)
F3=Exit F12=Cancel
Enter the IP-address or Network name/NetServer Name of the System i you work
on. This name can be found with the command APF3812/DSPNETSVRA, or can be
found under "other computers" on your System i Access connected W indows PC. This
option is used in relation to the PCL viewer and the DDM features. If you are in doubt
you can also specify the IP address of the System i - without surrounding ‘’.