InterForm Manual - System & Method

Allow additional types
selected for this spooled file line - unless the field ‘Allow additional
types’ has been set to ‘Y’.
As indicated above, this can make it possible to assign more than one
line type to one spooled file line. This may be useful if you e.g. have 2 or
more columns in the spooled file. The value of this parameter can be
seen on screen XML310D (shown above) as a ‘+’ or ‘-‘ to the right of the
line type.
Include lines above If you want to assign the same line type to a number of preceding
spooled file lines, then you can state just how many lines above the one
selected by the condition (stated in the bottom of the screen), that should
also have this line type. (The first of these lines will later be referenced to
as line 1).
Include lines below Simular to the previous field - only including spooled lines below the
condition.
You may notice the syntax for stating an interval of lines and/or positions above. Here we are
conditioning on the spooled file line interval 30 to 42 and searching the positions 1-30: If these
positions are not blank (within the line interval), then the line is a ‘DETAIL’ line. You may also
notice, that the operator can be prompted with F4 (see possible values on page 247), and that the
compare value should not be stated with hyphens (‘’).
Later you can search for specific variables in the spooled file, conditioned on line type(s) and/or
page type(s).
XML structure and data
Under this option you define the structure of the nodes within the XML file:
Work with XML nodes XML350D
XML definition name . : XML_DEMO
Position to . . . . . . Sequence number
Type options, press Enter.
2=Change 3=Copy 4=Delete 5=Display 12=Field definitions
Opt SeqNbr XML path
1 /Root
2 /Root//Document
3 /Root/Document//DetailLine
F3=Exit F6=Create F11=View 2 F12=Cancel
Press F6=Create to add new nodes:
End
InterForm A/S 249